Peerless-industries A100IWBMOUNT Manuel d'utilisateur télécharger pdf (Page 5)

ISSUED: 04-08-08 SHEET #: 055-9094-2 06-06-08

Visit the Peerless Web Site at www.peerlessmounts.com For customer care call 1-800-865-2112 or 708-865-8870.

5 of 16

Make sure that the mounting holes are on the stud centerline. Drill six 5/32" (4 mm) dia. holes 2-1/2" (65 mm) deep.

Fasten two #14 x 2.5" wood screws (Q) into top mounting holes leaving a .25" of exposed thread as shown. Hook

wall mount assembly (A) onto #14 x 2.5" wood screws (Q) as shown in fig. 2.1.

Fasten four #14 x 2.5" wood screws (Q) into wall mount assembly (A) as shown in fig. 2.2. Make sure that the wall

mount assembly (A) is level, tighten all six #14 x 2.5" wood screws (Q).

Skip to step 3.

Installation to Wood Stud Wall

• Installer must verify that the supporting surface will safely support the combined load of the equipment and all attached

hardware and components.

• Tighten wood screws so that wall plate is firmly attached, but do not overtighten. Overtightening can damage the

screws, greatly reducing their holding power.

• Never tighten in excess of 80 in. • lb (9 N.M.).

• Make sure that mounting screws are anchored into the center of the stud. The use of an "edge to edge" stud finder is

highly recommended.

• Hardware provided is for attachment of mount through standard thickness drywall or plaster into wood studs. Installers

are responsible to provide hardware for other types of mounting situations.

WARNING

fig. 2.1

fig. 2.2

CARRIAGE

.25"

1 2 3 4 5 6 7 8 9 10 ... 15 16

Pas de commentaire

Peerless-industries A100IWBMOUNT Manuel d'utilisateur Page 5