Peerless-industries A100IWBMOUNT Manuel d'utilisateur télécharger pdf (Page 16)

ISSUED: 04-08-08 SHEET #: 055-9094-2 06-06-08

Visit the Peerless Web Site at www.peerlessmounts.com For customer care call 1-800-865-2112 or 708-865-8870.

16 of 16

To adjust yaw (swivel): Loosen screw on projector mount assembly (J) indicated below until projector mount

can be rotated. Rotate mount to desired position and retighten screw.

To adjust pitch (forward and backward tilt): Turn knob on back of mount as shown below. Pull knob out and

turn by hand for easy adjustment or insert #2 phillips screwdriver in end of knob and turn.

To adjust roll (side to side tilt): Turn knob on side of mount as shown below. Pull knob out and turn by hand

for easy adjustment or insert #2 phillips screwdriver in end of knob and turn.

Projector Alignment

SCREW FOR YAW

(SWIVEL) STOP

KNOB FOR ROLL

ADJUSTMENT

KNOB FOR PITCH

ADJUSTMENT

BACK OF MOUNT

To prevent tampering with the pitch and roll adjustments: Tighten the two tamper resistant security screws

on the projector mount assembly (J) using 4 mm security allen wrench (V) to lock the pitch and roll adjustments

as shown below.

NOTE: Tighten screws firmly, but do not overtighten. Overtightening can damage the mount.

• Do not adjust pitch or roll while tamper resistant security screws are fully engaged.

• Loosen the two tamper resistant security screws one complete turn before adjusting the projector mount assembly or

damage may occur.

CAUTION

ARROW INDICATES

FRONT OF MOUNT

TO LOCK ROLL TIGHTEN

TAMPER RESISTANT

SECURITY SCREW

TO LOCK PITCH TIGHTEN

TAMPER RESISTANT

SECURITY SCREW

FRONT VIEW

SIDE VIEW

All other brand and product names are trademarks or registered trademarks of their respective owners.

16-1

fig. 16.1

1 2 ... 11 12 13 14 15 16

Pas de commentaire

Peerless-industries A100IWBMOUNT Manuel d'utilisateur Page 16