Peerless-industries A100IWBMOUNT Manuel d'utilisateur télécharger pdf (Page 12)

ISSUED: 04-08-08 SHEET #: 055-9094-2 06-06-08

Visit the Peerless Web Site at www.peerlessmounts.com For customer care call 1-800-865-2112 or 708-865-8870.

12 of 16

FRONT VIEW

fig. 10.3

Arrow on projector mount assembly (J) indicates front of mount. The arrow of projector mount assembly (J) should

face towards the round tube on projector arm (C).

Fasten projector mount assembly (J) to projector arm (C) using two 1/4-20 x 1.0" hex head screws (N), four 0.25" ID

nylon washers (P) and slide plate (I) as shown in fig. 10.2 and 10.3. Do not tighten 1/4-20 x 1.0" hex head

screws (N) fully to allow for adjustment. Insert rectangle plug (S) into projector arm (C) as shown in fig. 10.2.

Position projector mount assembly (J) so that hole corresponding to your size screen in projector arm (C) is in the

center of projector mount assembly (J) as shown in fig. 10.1. Securely tighten both 1/4-20 x 1.0" hex head screws

(N). NOTE: This can be adjusted during final projector alignment if needed.

fig. 10.2

Bottom View

fig. 10.1

77" SCREEN

63" SCREEN

ARROW INDICATES

FRONT OF MOUNT

ROUND TUBE

1 2 ... 7 8 9 10 11 12 13 14 15 16

Pas de commentaire

Peerless-industries A100IWBMOUNT Manuel d'utilisateur Page 12